Green Stuff World - Model railway graffiti decals 1:87 HO (Set-2)

Green Stuff World - Model railway graffiti decals 1:87 HO (Set-2)

SKU: 367533
GTIN: 8435646532691
Category: Waterslide Decals
Manufacturers: Green Stuff World

9,50 €

incl. 19% VAT , plus

Available immediately
Delivery time: 2 - 4 Workdays (DE - int. shipments may differ)

Description

This set includes 2 sheets of full colour opaque high-detailed waterslide decals. Decals are to be applied with water; no solvent is required. You can also use some GSW Decal Softener and GSW Decal Fixer solutions to improve and protect the finish on uneven or rough surfaces.

Each sheet of model railway decal sheet contains a wide variety of graffiti in different sizes and shapes that will allow you to customize your train cars and other railway vehicles in your model or diorama. Some of the designs include cutouts at the bottom to replicate those found in real life, as many trains are often interrupted by door frames, the underside of the car, or mechanical elements. Urban artists paint on whatever is available, and often do not continue below certain elements.

Scale 1/87 HO
Sheets: 2 per package
Size: 148 x 210mm (A5)

BASIC INSTRUCTIONS
1.- Cut the decal out as close as you can to the outer edge of the image. For better results, use a brand-new blade in your cutter.
2.- Pick the decal up with your tweezers and let your decal soak in water for about 20 seconds. Warm water may help with this process.
3.- Use a paintbrush to gently push the decal off the sheet and onto the model. That's all, folks!

ADVANCED INSTRUCTIONS
4.- Before applying it to the model, once the decal has soaked long enough, apply a bit of GSW Decal Fixer to the surface of the model where you are planning to set your decal. GSW Decal Fixer protects the paint beneath and smooths the surface, thereby helping to prevent silvering. Use a paintbrush to gently push the decal off the sheet and onto the model. If it is hard to move the decal around, adding a bit more GSW Decal Fixer or water will help the decal float on the surface until it is positioned correctly.
5.- If the surface where you want to apply the flat decal is curved, like a shoulder pad, your decal could become wrinkled. To avoid this, once your decal is in place, apply GSW Decal Softener. Let the softener react, and it will help remove wrinkles, as it adapts to the curved surface underneath. Repeat this step 2-3 times till wrinkles are removed.
Remove any excess with a cotton swab to remove the liquid caught between the decal and the surface. Roll the swab over the decal so it does not lift from the surface. You can also use a paper towel to press down on the decal in a rolling motion to remove the excess liquid. By using GSW Decal Softener, the relief cuts to remove wrinkles in your decal will not be needed.
6.- Finally, apply GSW Decal Fixer again to the decal and the surface of the model where we have been working to unify the surface. Coat it as normal with matt or gloss varnish if you consider it necessary to remove or add a glossy finish.

Item information	Value
Condition:	Sealed